VIEWPRO Gimbal Docking User Guide

Prodott: Serial Gimbal for KLV Setting
Aġġornat: 2025.08.06
Rekwiżiti tal-Konnessjoni tal-Gimbal:
- Is-swiċċ tal-ibgħat tal-UDP huwa miftuħ
- UDP send IP: 192.168.2.117 (aġġustabbli)
- UDP send port: 55012

Gimbal connection, check the following
- Is-swiċċ tal-ibgħat tal-UDP huwa miftuħ
- UDP send ip is 192.168.2.117,this is your PC ip,you can change your PC ip to 117 or change here to adapt your PC ip, but the segment should be same as “2”.
- UDP send port is 55012
- If you change any camera’s setting, please click “submit” and reboot.
Check video via udp
Send command AA 55 2F 04 FF via serial port or on viewKmand estiż ta' link, Iżda permezz tal-port tas-serje huwa aħjar. U erġa' ibda l-gimbal.
Use the serial port assistant to send the following commands at intervals of 1000ms to simulate GPS information.
- 55 AA DC 2D B1 07 00 00 00 00 00 00 00 00 8F FF 62 E3 23 6C 94 50 96 33 00 00 00 0D 40 1D AD 43 A2 68 BB 00 00 27 10 00 00 00 F0 00 00 00 00 4C
- On viewlink, tista' tikseb informazzjoni simulata tal-GPS hawn.
On viewIftaħ il-link “KLV”, u kklikkja xellug/lemin/fuq/isfel, il-valur tal-angoli se jinbidel; Ikklikkja “zoom in/out, il-valur tal-FOV se jinbidel. Dan ifisser li l-funzjoni KLV hija OK.
Connect gimbal serial port to FC, make sure gimbal can get GPS from FC, the time data will also be changing. According the document 《Settings for the open-source Viewlink Gimbal Docking.pdf 》.