Autonomous Levitate2 Smart Desk
ATTENZJONI
AQRA U SEGWI L-ISTRUZZJONIJIET TAL-ASSEMBLAĠĠ BIR-REQQA QABEL L-UŻU.
PARTIJIET INKLUŻI
GWIDA GĦALL-ASSEMBLEA
ASSEMBLEA TAL-KOLONNA
UPRIGHT DESK FRAME
DESK LEG WIRING
- Secure all connections with 32 screws A, then tighten with wrench G
- Connect the connectors on Columns A & B through the Short Crossbeam
Nota: After connecting, place the cable and cable head into the Crossbeam
DESK LEG WIRING
Connect the connectors on Columns C & D through the Short Crossbeam
Connect 2 Motor Cords & Keypad Cord to Column B, then connect 2 Motor Cords to Column C through Long Crossbeam 2
Nota: After connecting, place the cable and cable head into the Crossbeam
SPLITTER ATTACHMENT
CABLE TRAY ASSEMBLY
- Insert 2 screws B. but tighten them halfway
- Attach the Cable Tray with 2 screws B (Step 1)
- Tighten 2 screws B (Step 1)
ĠESTJONI TAL-CABLE
- Connect the Keypad & Power Cord End to the Control Box, then plug the Power Cord Head into the extension socket
- Connect the 4 Motor Connectors to the Control Box
DESK POSITIONING
- Unbox the desk top and place it on the frame, aligning the surface with the screw holes
- Insert 16 screws C with screwdriver
DESK & SPLITTER CONNECTION
- Insert the Hand screw E to secure the Cable Tray
- Use a screwdriver to attach the Splitter to the surface with 2 screws D. then connect the Sensor Connector to the Splitter
- Use Zip Ties to organize the cables
INSTALLAZZJONI AĊĊESSORJU
- Put the Main Power Cord into the Upper Tube, attach the Upper Tube to the Column B
- Attach the Cable Organizer to the Long Crossbeam 2
GWIDA GĦALL-UTENT
How to use the two buttons under your desk
Irrisettja
- Press and hold the+ and – buttons together for 3 seconds.
- The desk will lower to its lowest position. Keep holding both buttons until you hear l beep, indicating the desk has reset (3 beeps indicate an error).
- Release the buttons after the beep to complete the reset.
Aġġusta l-Għoli tal-Iskrivanija
- To Raise the Desk
Press and hold the + button. Release it when the desk reaches your desired height. - To Lower the Desk
Press and hold the – button. Release it when the desk reaches your desired height.
Funzjoni tal-Memorja
Save Memory Position 1:
- Adjust the desk to your preferred height.
- Double-click the+ button. The desk will beep to confirm.
- Double-clicking the+ button again will overwrite the previous setting.
Save Memory Position 2:
- Adjust the desk to your preferred height.
- Double-click the – button. The desk will beep to confirm.
- Double-clicking the – button again will overwrite the previous setting.
Recall Memory Positions:
- Press the + button once to move to Memory Position 1.
- Press the – button once to move to Memory Position 2.
Nota: The sensor and keypad cannot be used at the same time. The control box responds to only one at a time.
Xi mistoqsijiet?
Iċċettja mat-tim tal-Appoġġ għall-Klijenti tagħna fuq www.autonomous.ai/help-center
Aħna qegħdin hawn biex ngħinu!
Dokumenti / Riżorsi
 |
Autonomous Levitate2 Smart Desk [pdfGwida għall-Utent 25mb, Levitate2 Smart Desk, Levitate2, Smart Desk, Desk |