Prodott Overview
The FRIZZLIFE ASR311 is a 1st stage replacement filter cartridge designed for use with FRIZZLIFE PX500 and PX500-A undersink reverse osmosis water filter systems. This advanced 2-in-1 composite filter combines polyester and carbon to effectively block fine debris and reduce particles such as sand, silt, rust, and other insoluble impurities from your water. It also conditions the water, which helps to prolong the service life of the RO membrane in your system.
Image: The FRIZZLIFE ASR311 Replacement Filter Cartridge, a white cylindrical filter with product information printed on its side.
Image: The FRIZZLIFE ASR311 filter shown alongside the FRIZZLIFE PX500/PX500-A reverse osmosis system, illustrating its compatibility.
Setup u Installazzjoni
Replacing the ASR311 filter is a quick and tool-free process, requiring only a single turn after shutting off the power supply to your system. Follow these steps for a smooth replacement:
- Preparazzjoni: Ensure the power supply to your FRIZZLIFE PX500 or PX500-A system is shut off and the water inlet valve is closed. Open your faucet to release any residual pressure in the system.
- Neħħi l-Filtru l-Qadim: Twist the expired filter cartridge counter-clockwise to release it. This action simultaneously closes the water input/output valve in the center of the cartridge, preventing water spillage. Pull the old filter out to remove it from the machine.
- Installa Filtru Ġdid: Insert the new ASR311 filter into the machine and twist it clockwise until it locks securely in place.
- Irrisettja l-Indikatur tal-Ħajja tal-Filtru: After changing the filter, you must reset the filter life indicator on your system. The reset button is typically located on the bottom left of the front of the machine, below the blue/red filter life indicator LEDs.
- Long press the "Reset" button for 3 seconds until the buzzer beeps. This allows you to select the filter you want to change.
- Press the "Reset" button repeatedly to cycle through the filters. The lifetime indicator of the currently selected filter will flash.
- Once the ASR311 filter's indicator is flashing, long-press the "Reset" button again for 3 seconds. You will hear a beep, and the selected filter's indicator will turn blue, confirming a successful reset. (If no operation is performed within 10 seconds, the system will automatically exit this mode.)
- Sistema ta' Aħsel: After resetting the filter life indicator, press the 'flush' button (located to the right of the reset button) to flush the system.
- Drain Old Filter (Optional): To release any water trapped in the old filter cartridge (approximately 3/4 cup), place the old filter cartridge facing down. Use a flat head screwdriver or similar flat lever bar placed horizontally between the black 'o' rings on the input/output ports to rotate the cut-off valve plate clockwise (back into the open position). Turn the input/output end of the filter down over a sink and shake or blow out the trapped water with compressed air.
Istruzzjonijiet Operattivi
Once the ASR311 filter cartridge is correctly installed and the system is flushed, the filter operates automatically as part of your FRIZZLIFE PX500 or PX500-A reverse osmosis system. It continuously filters your water, providing clean and purified water on demand.
Manutenzjoni
Regular replacement of the ASR311 composite filter is crucial for maintaining optimal water quality and system performance. It is recommended to replace the ASR311 composite filter every 6 xhur.
Jekk jogħġbok innota: The actual replacement period can vary significantly depending on your local feed water quality and your daily water usage. The system's built-in indicator lights will signal when a filter replacement is needed (typically turning red).
Issolvi l-problemi
- Dawl Indikatur Aħmar: If the filter life indicator light turns red, it signifies that the filter needs to be replaced. Follow the steps in the "Setup and Installation" section to replace the filter and reset the indicator.
- Fluss ta' Ilma Mnaqqas: A noticeable reduction in water flow from your system may indicate that the filter is clogged and needs replacement. Refer to the maintenance schedule and replacement instructions.
- Togħma jew Riħa Mhux tas-Soltu: If you detect an unusual taste or odor in your filtered water, it may be a sign that the filter's effectiveness has diminished. Replace the filter immediately.
Speċifikazzjonijiet
| Attribut | Dettall |
|---|---|
| Numru tal-Mudell | ASR311 |
| Mudelli Kompatibbli | FRIZZLIFE PX500, PX500-A |
| Tip ta 'filtru | 2-in-1 Composite Filter (PPC Sediment Filter) |
| Materjal | Polyester and Carbon Fiber |
| Piż tal-oġġett | 0.282 uqija (madwar 8 gramma) |
| Ċertifikazzjoni ta' Ittestjar Estern | NSF |
| Benefiċċji tal-Prodott | Blocks fine debris, reduces particles (sand, silt, rust), conditions water, prolongs RO membrane life. |
| Recommended Service Life | 6 months (or 450-500 gallons), depending on water quality and usage. |
| UPC | 850026491104 |
Garanzija u Appoġġ
For product support, inquiries, or to learn more about FRIZZLIFE products, please visit the official FRIZZLIFE website. While specific warranty details for this replacement filter are not provided in this manual, FRIZZLIFE aims to provide responsive customer service, typically responding to email inquiries within the same day.
Uffiċjali Websit: www.frizzlife.com
Image: A banner displaying the FRIZZLIFE slogan "WATER AS IT SHOULD BE" with a person enjoying a glass of water in a kitchen setting.
