SkyTech 9800325

Skytech 9800325 SKY-3301P2 Backlit Programmable Fireplace Remote Control User Manual

Model: 9800325 | Brand: SkyTech

Introduzzjoni

This manual provides comprehensive instructions for the installation, operation, and maintenance of the Skytech 9800325 SKY-3301P2 remote control system. This system is designed to offer safe, reliable, and user-friendly control for gas heating appliances. It supports both thermostatic and manual operation from the transmitter.

The system utilizes radio frequencies (RF) for communication within a 20-foot range, employing non-directional signals. Each system operates on one of 1,048,567 security codes, pre-programmed at the factory. It is essential to match the remote receiver's code to that of the transmitter before initial use.

Kontenut tal-Pakkett

Upon unpacking, verify that all components are present and undamaged. The package should include:

  • Transmitter (Remote Control Unit)
  • Unità Riċevitur
  • Wall Holder for Transmitter
  • Pjanċa tal-Ħajt
  • Istruzzjonijiet għall-installazzjoni
  • Batteries (2 AAA for transmitter, 4 AA for receiver)
Skytech 9800325 SKY-3301P2 Remote Control System Components

Stampa 1: Fuqview of the Skytech 9800325 SKY-3301P2 remote control system, showing the handheld transmitter, the wall-mounted receiver, and the wired receiver box.

Setup u Installazzjoni

1. Installazzjoni tal-batterija

Trasmettitur: Open the battery compartment on the back of the transmitter and insert two (2) AAA batteries, observing the correct polarity. Close the compartment securely.

Riċevitur: Open the battery compartment on the receiver unit and insert four (4) AA batteries, observing the correct polarity. Close the compartment securely.

2. Tqegħid u Wajers tar-Riċevitur

The receiver can be installed in the wall, on the hearth, or under the fireplace behind the control access panel. Ensure the receiver is placed in a location that allows for proper signal reception from the transmitter and is not exposed to excessive heat.

Connect the two wires from the receiver to the appropriate terminals on your gas heating appliance's control valve. Refer to your appliance's manual for specific wiring instructions. Ensure all connections are secure and properly insulated.

Skytech 9800325 SKY-3301P2 Receiver Unit

Stampa 2: Close-up of the receiver unit, showing the 'OFF', 'REMOTE', 'ON' slider switch and 'LEARN' button. This unit connects to the fireplace.

3. Matching Security Codes (Learning Function)

The transmitter and receiver are factory-matched. However, if they lose synchronization or if you are replacing a component, you may need to re-match them:

  1. Ensure batteries are installed in both the transmitter and receiver.
  2. Locate the 'LEARN' button on the receiver unit.
  3. Press and hold the 'LEARN' button on the receiver until you hear a series of beeps (approximately 1-2 seconds).
  4. Within 10 seconds, press any button on the transmitter. The receiver will emit another series of beeps, confirming that the codes have been matched.

If the matching process fails, repeat the steps. Ensure the transmitter is within 20 feet of the receiver during this process.

Istruzzjonijiet Operattivi

Kontrolli tat-Trasmettitur

Skytech 9800325 SKY-3301P2 Transmitter Display and Buttons

Stampa 3: Close-up of the handheld transmitter, showing the backlit LCD display with room temperature and set temperature, and the 'DOWN', 'MODE', 'UP' buttons. The flip cover conceals 'PROG' and 'SET' buttons.

  • Buttuna UP: Increases temperature setting or navigates menu options.
  • Buttuna 'l isfel: Decreases temperature setting or navigates menu options.
  • Buttuna MODE: Cycles through operating modes (ON, THERMO, OFF, PROGRAM).
  • PROG Button (under flip cover): Used for programming thermostat schedules.
  • SET Button (under flip cover): Used to confirm settings or enter programming mode.

Receiver Slider Switch

The receiver unit has a three-position slider switch:

  • FUQ: Manually turns the appliance ON, bypassing remote control.
  • REMOT: Allows the appliance to be controlled by the transmitter.
  • MITFI: Manually turns the appliance OFF, bypassing remote control.

For normal operation with the remote control, ensure the receiver switch is set to REMOTO.

Modi Operattivi

Agħfas il- MODALITÀ button on the transmitter to cycle through the following modes:

  • FUQ: The appliance will turn on and remain on until switched off.
  • THERMO: The appliance will operate based on the set temperature. When the room temperature falls below the set temperature, the appliance will turn on. When the room temperature rises above the set temperature, the appliance will turn off.
  • MITFI: The appliance will remain off.
  • PROGRAMM: The appliance will follow the programmed schedule for temperature control.

Setting the Temperature (THERMO Mode)

  1. Agħfas il- MODALITÀ Agħfas il-buttuna sakemm tidher "THERMO" fuq l-LCD.
  2. Uża l- UP or 'L isfel buttons to adjust the desired set temperature. The display will show both the current room temperature and the set temperature.

Programming a Schedule (PROGRAM Mode)

The 3301P2 allows for programmable temperature settings. Lift the flip cover on the transmitter to access the PROGRAMM u SET buttuni.

  1. Agħfas il- MODALITÀ button until "PROGRAM" is displayed on the LCD.
  2. Agħfas il- PROGRAMM buttuna biex tidħol fil-mod ta' programmar.
  3. Uża l- UP or 'L isfel buttons to adjust the time and temperature settings for each program period (P1, P2).
  4. Agħfas SET biex tikkonferma kull setting u tgħaddi għal dak li jmiss.
  5. The system typically allows for two program periods (P1 for morning/day, P2 for evening/night) with separate ON/OFF times and temperatures. Consult the detailed instructions provided with the product for specific programming steps, as these can be intricate.

Nota: The programming interface may require careful attention to detail. If you encounter difficulties, refer to the troubleshooting section or contact support.

Manutenzjoni

Sostituzzjoni tal-batterija

Replace batteries in both the transmitter and receiver when the low battery indicator appears on the transmitter's LCD, or if the remote control range decreases significantly. Use high-quality alkaline batteries for optimal performance.

  • Trasmettitur: 2 x batteriji AAA.
  • Riċevitur: 4 x batteriji AA.

Always replace all batteries at the same time. Dispose of old batteries responsibly according to local regulations.

Tindif

Wipe the transmitter and receiver with a soft, dry cloth. Do not use abrasive cleaners or immerse the units in water.

Issolvi l-problemi

ProblemaKawża PossibbliSoluzzjoni
Il-kontroll remot mhux qed jirrispondi.
  • Batteriji baxxi jew mejta fit-trasmettitur jew fir-riċevitur.
  • Receiver switch not in "REMOTE" position.
  • Transmitter and receiver codes are not matched.
  • Trasmettitur barra mill-firxa.
  • Ibdel il-batteriji kollha fiż-żewġ unitajiet.
  • Issettja s-swiċċ tar-riċevitur fuq "REMOTE".
  • Re-match security codes (see Setup section).
  • Move transmitter closer to the receiver (within 20 feet).
Appliance does not turn on/off in THERMO mode.
  • Set temperature is too close to room temperature.
  • Incorrect wiring to the appliance.
  • Adjust set temperature to create a larger differential.
  • Verify wiring connections to the gas appliance.
Id-displej tal-LCD huwa mċajpar jew vojt.Low batteries in the transmitter.Replace AAA batteries in the transmitter.

Speċifikazzjonijiet

  • Mudell: 9800325 (SKY-3301P2)
  • Ditta: SkyTech
  • Dimensjonijiet tal-Prodott: 6.5 x 3.6 x 3 inches (Transmitter and Receiver combined, approximate)
  • Piż: 12.96 uqija (approssimattiv)
  • Qawwa tat-Trasmettitur: 2 x batteriji AAA
  • Qawwa tar-riċevitur: 4 x batteriji AA
  • Tip ta' Kontroll: Imbotta Buttuna
  • Karatteristika Speċjali: Programmable Thermostat, Backlit Display
  • Medda bla fili: Up to 20 feet (non-directional RF)
  • Kodiċi tas-Sigurtà: 1,048,567 kodiċi uniku
  • Użi Speċifiċi: Fireplace Control, Thermostat Control, Indoor Residential Environments

Garanzija u Appoġġ

For warranty information or technical support, please refer to the documentation included with your purchase or visit the official SkyTech websit. Żomm il-prova tax-xiri tiegħek għal talbiet ta' garanzija.

Manifattur: Skytech

For further assistance, contact SkyTech customer service.

Dokumenti Relatati - 9800325

Preview Sistema ta' Kontroll mill-Bogħod tan-Nar Skytech 5301P: Gwida għall-Installazzjoni u t-Tħaddim
Din il-gwida tipprovdi struzzjonijiet komprensivi għall-installazzjoni, it-tħaddim, u s-soluzzjoni tal-problemi tas-sistema ta' kontroll remot Skytech 5301P għal fuklari tal-gass. Tgħallem dwar il-funzjonijiet tat-trasmettitur, is-setup tar-riċevitur, il-wajers, it-termostat u l-modi tal-programm, il-karatteristiċi tas-sigurtà, u informazzjoni dwar il-garanzija.
Preview Sistema ta' Kontroll mill-Bogħod għal Nar tal-Gass Skytech 5310: Istruzzjonijiet għall-Installazzjoni u t-Tħaddim
Gwida komprensiva għall-installazzjoni u t-tħaddim tas-sistema ta' kontroll remot Skytech 5310 għal apparati tat-tisħin bil-gass, li tkopri s-setup, il-funzjonijiet, il-karatteristiċi ta' sigurtà, is-soluzzjoni tal-problemi, u l-garanzija.
Preview Istruzzjonijiet għall-Installazzjoni u t-Tħaddim ta' Skytech 3002
Dan id-dokument jipprovdi struzzjonijiet dettaljati għall-installazzjoni u t-tħaddim tas-sistema ta' kontroll remot Skytech 3002, iddisinjata għal tħaddim sikur u faċli għall-utent ta' apparati tat-tisħin bil-gass.
Preview Istruzzjonijiet ta' Installazzjoni u Tħaddim ta' Skytech RCT-MLT III
Gwida komprensiva għall-installazzjoni u t-tħaddim tas-sistema ta' kontroll remot Skytech RCT-MLT III għal apparati tat-tisħin bil-gass. Tkopri s-setup, il-funzjonijiet, is-soluzzjoni tal-problemi, ir-rekwiżiti tal-FCC, u informazzjoni dwar il-garanzija.
Preview Sistema ta' Kontroll mill-Bogħod Programmabbli Skytech 3301P: Istruzzjonijiet għall-Installazzjoni u t-Tħaddim
Gwida komprensiva għall-installazzjoni, it-tħaddim u l-ipprogrammar tas-sistema ta' kontroll remot Skytech 3301P għal fuklari tal-gass, li tkopri s-setup, il-modi, il-karatteristiċi tas-sigurtà, il-wajers u informazzjoni dwar il-garanzija.
Preview Kontroll mill-Bogħod tan-Nar Skytech 3301: Istruzzjonijiet għall-Installazzjoni u t-Tħaddim
Gwida komprensiva għall-installazzjoni u t-tħaddim tas-sistema ta' kontroll remot Skytech 3301 għal fuklari tal-gass, li tkopri s-setup, il-funzjonijiet, il-karatteristiċi tas-sigurtà, u s-soluzzjoni tal-problemi.