Manwal tal-Istruzzjonijiet tal-Arloġġ tal-Allarm Kubu tad-Disinn Gingko (Mudell GK08W6)

1. Introduzzjoni

The Gingko Design Cube Alarm Clock (Model GK08W6) is a digital alarm clock featuring an LED display that can show time, date, and temperature. It incorporates a sound-activated display function for energy saving. This manual provides comprehensive instructions for setting up, operating, and maintaining your device.

Kontenut tal-Pakkett:

Gingko Design Cube Alarm Clock (GK08W6)
Kejbil tal-Enerġija USB
Manwal ta' Istruzzjoni

2. Setup

2.1 It-Tħaddim tal-Apparat

The clock can be powered by either 3x AAA batteries (not included) or via the supplied USB cable connected to a USB power adapter (not included) or a computer USB port.

Qawwa tal-batterija: Open the battery compartment on the back of the clock and insert 3x AAA batteries, ensuring correct polarity.
Qawwa tal-USB: Connect the small end of the USB cable to the DC 5V port on the back of the clock and the larger end to a USB power source.

For continuous display, USB power is recommended. Battery power is suitable for portable use or as a backup, but the display will typically turn off after a short period to conserve energy.

Gingko Design Cube Alarm Clock displaying 12:00 on a gray wood-effect surface.

Stampa 1: Quddiem view of the Gingko Design Cube Alarm Clock displaying the time.

3. Istruzzjonijiet Operattivi

The control buttons are located on the back of the clock. These typically include 'SET', 'UP', and 'DOWN' buttons.

3.1 L-issettjar tal-Ħin u d-Data

Press and hold the 'SET' button for 3 seconds to enter time setting mode. The display will flash.
Use the 'UP' and 'DOWN' buttons to adjust the hour. Press 'SET' to confirm and move to minutes.
Adjust minutes with 'UP'/'DOWN', then press 'SET'.
Continue this process to set the year, month, and day.
After setting the day, press 'SET' to exit the setting mode.

3.2 Issettjar tal-Allarm

The clock supports up to three independent alarms (A1, A2, A3).

Press the 'SET' button repeatedly until 'A1' (or A2, A3) appears on the display.
Press and hold 'SET' for 3 seconds. The alarm hour will flash.
Use 'UP'/'DOWN' to set the alarm hour, then press 'SET'.
Use 'UP'/'DOWN' to set the alarm minute, then press 'SET'.
The display will show 'ON:A1' or 'OFF:A1'. Use 'UP'/'DOWN' to toggle the alarm on or off. Press 'SET' to confirm.
Repeat for A2 and A3 if desired.

3.3 Funzjoni Snooze

When the alarm sounds, press any button (except 'SET' or 'DOWN' during alarm setting) to activate the snooze function. The alarm will sound again after approximately 5 minutes.

3.4 Modi tal-Wiri

The clock offers various display modes. Press the 'UP' button to cycle through them:

dp-1: Time, date, and temperature display alternately.
dp-2: Time display only.

Gingko Design Cube Alarm Clock on a desk, displaying the date 1:17.

Image 2: The clock displaying the date (month and day).

Gingko Design Cube Alarm Clock on a desk, displaying the temperature 19 degrees Celsius.

Image 3: The clock displaying the temperature in Celsius.

3.5 Sound Activation Mode

In sound activation mode, the display will turn off when the room is quiet to save power. It will light up again in response to a sound (e.g., a clap, finger snap, or gentle tap on the clock/surface).

To activate/deactivate sound activation mode, press the 'DOWN' button.
When 'ON:SD' is displayed, sound activation is active.
When '--:SD' is displayed, sound activation is inactive, and the display will remain on (if USB powered).

Gingko Design Cube Alarm Clock with its display off, sitting on a dark desk next to a laptop.

Image 4: The clock with its display off, indicating sound activation mode is active and the environment is quiet.

4. Manutenzjoni

4.1 Tindif

To clean the clock, gently wipe the surface with a soft, dry cloth. Avoid using abrasive cleaners, solvents, or excessive moisture, as these can damage the finish or internal components.

4.2 Sostituzzjoni tal-batterija

If using battery power, replace the AAA batteries when the display dims or the clock functions become unreliable. Ensure the clock is powered off or disconnected from USB before replacing batteries. Dispose of old batteries responsibly.

5 Issolvi l-problemi

Display is off or dim:
- Check battery level and replace if necessary.
- Ensure USB power cable is securely connected.
- If in sound activation mode, make a sound to activate the display.
L-arloġġ mhux qed iżomm il-ħin preċiż:
- Re-set the time following the instructions in Section 3.1.
- Ensure stable power supply (either fresh batteries or consistent USB power).
L-allarm ma ħossx:
- Verify that the alarm is set to 'ON' (e.g., 'ON:A1') in the alarm settings.
- Check the alarm time to ensure it is correctly set.
Buttuni li ma jirrispondux:
- Disconnect power (both USB and batteries) for a few minutes, then reconnect to perform a soft reset.

6. Speċifikazzjonijiet

Brand	Gingko
Numru tal-Mudell	GK08W6
Kulur	Griż
Materjal	Injam
Tip ta 'Wiri	LED diġitali
Sors tal-Enerġija	Battery Powered (3x AAA, not included) or USB (DC 5V)
Karatteristiċi Speċjali	Alarm, Snooze, Sound Activation, Time/Date/Temperature Display
Dimensjonijiet tal-Prodott	2.68 x 2.68 x 2.68 pulzieri
Piż tal-oġġett	6.3 uqija (179.99 Grammi)

7. Garanzija u Appoġġ

For warranty information and customer support, please refer to the documentation included with your purchase or visit the official Gingko Design websit. Żomm il-prova tax-xiri tiegħek għal talbiet ta' garanzija.

Websit: www.gingkodesign.com

	Gingko Tumbler Click Clock: Manwal għall-Utent fil-Qosor Manwal tal-utent għall-Gingko Tumbler Click Clock, li jiddeskrivi l-karatteristiċi, is-setup, it-tħaddim, u l-kura tiegħu. Tgħallem kif tissettja l-ħin, l-allarmi, u timmaniġġja l-modi tal-wiri.
	Manwal tal-Utent tal-Arloġġ Click Gingko Cube Plus Gwida komprensiva dwar kif twaqqaf, tħaddem, u żżomm l-arloġġ Gingko Cube Plus Click Clock, inklużi karatteristiċi bħall-issettjar tal-ħin, funzjonijiet ta' allarm, attivazzjoni tal-ħoss, u operazzjonijiet ta' flip.
	Arloġġ tal-Allarm Diġitali Gingko Click Clock - Karatteristiċi, Settings, u Manwal Gwida komprensiva għall-Gingko Click Clock, arloġġ tal-allarm diġitali tal-injam. Tgħallem dwar il-karatteristiċi tiegħu, kif tissettja l-ħin, id-data, l-allarmi, il-format tat-temperatura, l-attivazzjoni tal-ħoss, u l-funzjoni snooze. Tinkludi struzzjonijiet għall-kura.
	Manwal tal-Utent Rapidu tal-Arloġġ Gingko Lumos - Konfigurazzjoni, Tħaddim, u Kura Gwida komprensiva għall-Arloġġ Gingko Lumos, li tkopri s-setup, l-iċċarġjar, il-kontrolli touch, is-settings tal-ħin u tal-allarm, il-modi tal-wiri, in-numru ta' snooze, il-funzjonijiet tad-dawl, il-kura tal-prodott, u informazzjoni dwar il-garanzija.
	Gingko clickclock: Manwal tal-Utent u Istruzzjonijiet tal-Arloġġ tal-Allarm Diġitali Manwal komprensiv għall-utent għall-arloġġ tal-allarm diġitali Gingko clickclock. Tgħallem kif tissettja l-ħin, id-data, it-temperatura, l-allarmi, tuża l-attivazzjoni tal-ħoss, u l-funzjonijiet ta' snooze. Jinkludi informazzjoni dwar il-kura tal-prodott.
	Gingko Smart Diffuser LampManwal tal-Utent u Gwida Manwal uffiċjali għall-utent għall-Gingko Smart Diffuser LampTgħallem dwar il-karatteristiċi tiegħu, kif tużah, l-iċċarġjar, il-kura, u l-informazzjoni dwar il-garanzija.

Gingko GK08W6

Gingko Design Cube Alarm Clock Instruction Manual