Introduzzjoni
This manual provides detailed instructions for the safe installation, operation, and maintenance of your Leviton 15 Amp, 120 Volt, Duplex Style Combination Single Pole Switch/Receptacle, Model 5225. This device combines a single-pole switch and a 15 Amp, 125 Volt grounding receptacle in a single unit, designed for commercial and residential applications.
Informazzjoni dwar is-Sigurtà
TWISSIJA: To avoid fire, shock, or death, turn off power at the circuit breaker or fuse box and test that power is off before wiring. This device must be installed in accordance with all national and local electrical codes.
- Dejjem skonnettja l-enerġija qabel ma taħdem fuq ċirkwiti elettriċi.
- Use only copper or copper-clad wire. Do not use aluminum wire with this device.
- Kun żgur li l-konnessjonijiet tal-wajer kollha huma siguri.
- Jekk m'intix ċert dwar xi parti minn dawn l-istruzzjonijiet, ikkonsulta electrician kwalifikat.
- Dan l-apparat huwa għal użu fuq ġewwa biss.
Kontenut tal-Pakkett
- One Leviton 15 Amp, 120 Volt, Duplex Style Combination Single Pole Switch/Receptacle (Model 5225-W)
Setup u Installazzjoni
- Itfi l-Enerġija: Locate the circuit breaker or fuse that supplies power to the outlet box where you intend to install the device. Turn it OFF. Verify power is off using a voltagtester.
- Remove Old Device (if applicable): Carefully remove the existing switch or receptacle from the wall box. Disconnect the wires, noting their connections.
- Ipprepara Wajers: Strip approximately 1/2 inch (12.7 mm) of insulation from each wire end. Ensure wires are straight.
- Identifika Terminals: The Leviton 5225 device has the following terminals:
- Viti tal-Art Aħdar: For the bare copper or green insulated ground wire.
- Viti tal-Fidda: For neutral (white) wires.
- Viti tar-ram: For hot (black) wires.
- Break-off Tabs: Located on the side of the device, these tabs connect the switch and receptacle to the same hot feed. If you need to control the switch and receptacle from separate power sources, carefully break off the tab connecting the brass screws.
- Konnessjonijiet tal-Wajer:
Wajer tal-art: Connect the bare copper or green insulated ground wire from the wall box to the green ground screw on the device. Tighten securely.
Wajer newtrali: Connect the white neutral wire from the wall box to one of the silver screws. Tighten securely.
Hot Wire (Power In): Connect the black hot wire (power source) from the wall box to one of the brass screws. Tighten securely.
Load Wire (for Switch): If the switch controls a light fixture or other load, connect the load wire to the remaining brass screw. If the switch and receptacle are on the same circuit, and the break-off tab is intact, the switch will control the receptacle. If the tab is broken, the switch will control a separate load connected to its brass screw, and the receptacle will be constantly powered.
- Apparat tal-Immuntar: Carefully fold the wires into the wall box. Secure the device to the wall box using the provided mounting screws.
- Installa l-Wallplate: Attach a standard wallplate (not included) over the device.
- Irrestawra l-Enerġija: Erġa’ ixgħel il-provvista tal-enerġija mis-circuit breaker jew mill-kaxxa tal-fjużijiet.
- Test: Test the switch and receptacle functionality.
Figura 1: Quddiem view of the Leviton 5225 combination switch and receptacle, showing the single pole switch at the top and the 15 Amp receptacle below.
Figura 2: Lura view of the Leviton 5225, illustrating the brass (hot), silver (neutral), and green (ground) wiring terminals, along with the break-off tab. The UPC 0078477965849 is visible.
Istruzzjonijiet Operattivi
The single-pole switch operates by toggling the lever up or down to control the connected load. The 15 Amp receptacle functions as a standard electrical outlet for plugging in devices. If the break-off tab is intact, the switch will control power to the receptacle. If the tab is removed, the switch and receptacle operate independently.
Manutenzjoni
This device requires minimal maintenance. Periodically inspect the device and wallplate for any signs of damage or wear. Clean with a soft, dry cloth. Do not use abrasive cleaners or solvents.
Issolvi l-problemi
- No Power to Receptacle/Switch: Check the circuit breaker or fuse. Ensure all wire connections are secure.
- Switch Not Controlling Receptacle: Verify that the break-off tab between the brass screws is intact if you intend for the switch to control the receptacle.
- Konnessjonijiet sfużi: If the device feels loose in the wall box, ensure mounting screws are tightened.
Speċifikazzjonijiet
| Karatteristika | Speċifikazzjoni |
|---|---|
| Numru tal-Mudell | 5225-w |
| Voltage | 120 Volts |
| Ampetà | 15 Amp (Switch), 15 Amp (Reċipjent) |
| Tip ta' Swiċċ | Arblu Uniku |
| Tip ta' Reċipjent | Duplex Style, Grounding |
| Materjal | Termoplastiku |
| Kulur | Abjad |
| Dimensjonijiet | 1.97 x 0.39 x 1.18 pulzieri; 2.4-il uqija |
| Approvazzjonijiet | UL 20, CSA C22.2 |
Figura 3: Ġenb view of the Leviton 5225, showing approximate dimensions of 4.4 inches (11 cm) in length.
Informazzjoni dwar Garanzija
Leviton provides a limited two-year warranty for this device. For specific details regarding warranty coverage and claims, please refer to the official Leviton websit jew ikkuntattja l-appoġġ tal-klijent.
Appoġġ
For technical assistance, product information, or customer service, please visit the official Leviton website or contact their customer support department. You can find contact information and additional resources at www.leviton.com.
