American Standard 9075120 Safe-T Heater Instruction Manual

1. Introduzzjoni

This manual provides essential information for the safe and efficient installation, operation, and maintenance of your American Standard 9075120 Safe-T Heater. This heater is designed to extend the comfort of your American Standard whirlpool by maintaining a constant water temperature, allowing for a longer, more relaxing soak. It is intended for quick and easy two-step installation in factory pre-plumbed whirlpool baths.

2. Informazzjoni Importanti dwar is-Sigurtà

Please read all instructions carefully before installation and operation. Failure to follow these instructions could result in electric shock, fire, property damage, or personal injury.

Sigurtà Elettrika: This unit operates on 120 Volts and draws approximately 1500 watts. It must be installed on a dedicated, properly grounded circuit protected by a Ground Fault Circuit Interrupter (GFCI) as required by local electrical codes. All electrical work should be performed by a qualified electrician.
Sigurtà tal-Ilma: Ensure all plumbing connections are secure and leak-free before operating the heater. Do not operate the heater if there is any visible damage to the unit or its wiring.
Installazzjoni professjonali: While designed for easy installation, professional plumbing and electrical installation is recommended to ensure compliance with all local codes and safety standards.
Użu Intenzjonat: This heater is specifically designed for use with American Standard whirlpool bathtubs. Do not attempt to use it with other systems unless explicitly approved by American Standard.
Ċertifikazzjoni UL: The Safe-T Heater is UL certified, indicating compliance with recognized safety standards.

3. Kontenut tal-Pakkett

Iċċekkja li l-komponenti kollha huma preżenti qabel tibda l-installazzjoni:

American Standard 9075120 Safe-T Heater unit
Manwal ta 'Istruzzjoni (dan id-dokument)

Note: Additional plumbing fittings or electrical components required for installation are typically not included and must be purchased separately.

4. Speċifikazzjonijiet tal-Prodott

Brand	Standard Amerikan
Numru tal-Mudell	9075120
Dimensjonijiet tal-Prodott	7.50" (Tul) x 4.81" (Wisa') x 3.56" (Għoli)
Piż tal-oġġett	1 lira
Kulur	Iswed
Voltage	120 Volts
Sors tal-Enerġija	AC/DC (Electric)
Tip ta 'Immuntar	Wall (typically mounted to the tub frame)
Ċertifikazzjoni	Elenkat UL

5. Setup u Installazzjoni

The American Standard 9075120 Safe-T Heater is designed for a two-step installation process, primarily for factory pre-plumbed American Standard whirlpool baths. It integrates into the existing plumbing system of the whirlpool.

5.1. Lista ta' Kontroll ta' Qabel l-Installazzjoni

Ensure the whirlpool tub is positioned correctly and accessible for plumbing and electrical connections.
Verify that a dedicated 120V, 15A (minimum) GFCI-protected electrical circuit is available for the heater. Consult a qualified electrician for proper wiring.
Confirm that the whirlpool plumbing includes the necessary connections for an inline heater.

5.2. Passi ta 'installazzjoni

Konnessjoni tal-plaming: Locate the designated inlet and outlet ports on your American Standard whirlpool tub's plumbing system for the Safe-T Heater. Connect the heater inline, ensuring a secure, watertight seal at both ends. Use appropriate plumbing sealant or tape as necessary. The heater typically connects to the circulation line of the whirlpool pump.
Konnessjoni Elettrika: Once the plumbing is secure and verified leak-free, connect the heater's power cord to the dedicated 120V GFCI-protected outlet. Ensure the power cord is routed safely and not pinched or exposed to water.

Image 1: American Standard 9075120 Safe-T Heater (Front View)

American Standard 9075120 Safe-T Heater, front view, showing the black control box with 'American Standard SAFE-T-HEATER' text and UL listing, mounted on a stainless steel cylindrical body with black end caps for plumbing connections.

This image displays the main unit of the American Standard 9075120 Safe-T Heater, highlighting its black control box with branding and UL certification, attached to a metallic cylindrical heating element. Black threaded end caps are visible for plumbing connections.

Image 2: American Standard 9075120 Safe-T Heater (Angled View)

American Standard 9075120 Safe-T Heater, angled view, showing the control panel with 'OVERHEAT PROTECTION' and 'RESET' button, and 'HEATER ON' indicator light.

This image provides an angled perspective of the Safe-T Heater, focusing on the control panel. Visible features include an 'OVERHEAT PROTECTION' label, a 'RESET' button, and a 'HEATER ON' indicator light, all on the black control box.

6. Istruzzjonijiet Operattivi

The American Standard Safe-T Heater operates automatically in conjunction with your whirlpool system.

Attivazzjoni Awtomatika: The heater is equipped with a flow switch or vacuum switch. It will automatically activate when water flow is detected through the whirlpool system (i.e., when the whirlpool pump is turned on). There is no separate on/off switch for the heater itself.
Manutenzjoni tat-Temperatura: The heater is designed to maintain the water temperature at a comfortable level, preventing it from cooling down during extended use of the whirlpool. It does not typically heat cold water to a desired temperature but rather sustains the temperature of the water already in the tub.
Dawl Indikatur: A 'HEATER ON' indicator light (visible on some models, refer to Image 2) will illuminate when the heating element is active.

7. Manutenzjoni

The American Standard Safe-T Heater requires minimal maintenance.

Spezzjoni regolari: Periodically inspect the heater and its connections for any signs of leaks, corrosion, or damage. Ensure electrical connections remain secure.
Tindif: Keep the exterior of the heater clean and free of dust or debris. Use a soft, damp drapp għat-tindif. Tużax tindif jew solventi li joborxu.
Winterization: If the whirlpool system is subject to freezing temperatures, ensure the heater and all associated plumbing are properly drained and winterized according to your whirlpool tub's instructions to prevent damage.

8 Issolvi l-problemi

If you experience issues with your Safe-T Heater, consult the following table:

Problema	Kawża Possibbli	Soluzzjoni
Heater not turning on / Water not staying warm	Ebda enerġija għall-unità. GFCI tfixkel. Fluss ta 'ilma insuffiċjenti. Flow switch malfunction. Protezzjoni kontra s-sħana żejda attivata.	Check electrical connections and ensure the unit is plugged in. Irrisettja l-interruttur tal-GFCI. Ensure the whirlpool pump is operating and there is adequate water circulation. If an 'OVERHEAT PROTECTION' light is on, press the 'RESET' button (refer to Image 2). Jekk il-problemi jippersistu, ikkuntattja tekniku kwalifikat.
Water temperature is too hot or too cold	Malfunzjoni tal-heater. Improper initial water temperature.	The Safe-T Heater maintains temperature; it does not regulate it to a specific set point. Ensure the initial water temperature is comfortable. If the heater is consistently overheating or underheating beyond its intended function, discontinue use and contact support.
Visible leaks from the heater connections	Konnessjonijiet tal-plumbing maħlula. Damaged seals or fittings.	Immediately turn off power to the unit and drain the tub. Tighten plumbing connections. Inspect seals and fittings for damage and replace if necessary. Jekk it-tnixxijiet jippersistu, ikkuntattja plamer kwalifikat.

9. Garanzija u Appoġġ

9.1. Garanzija Limitata tul il-Ħajja

The American Standard 9075120 Safe-T Heater is backed by a Limited Lifetime Warranty. This warranty covers defects in material and workmanship under normal use and service. For specific terms, conditions, and limitations of the warranty, please refer to the warranty documentation included with your original purchase or visit the official American Standard websit.

9.2. Appoġġ għall-Klijent

For technical assistance, warranty claims, or replacement parts, please contact American Standard customer service. Contact information can typically be found on the American Standard website or in your original product packaging.

	Ħiters tal-Ilma li Jikkondensaw mingħajr Tank Standard Amerikan \| TCWH180S-AS, TCWH199S-AS Esplora l-karatteristiċi, l-ispeċifikazzjonijiet, u l-benefiċċji tal-Heaters tal-Ilma Residenzjali b'Kondensazzjoni Tankless ta' American Standard (mudelli TCWH180S-AS u TCWH199S-AS). Effiċjenza għolja, disinn kompatt, u teknoloġija avvanzata għal ilma sħun affidabbli.
	American Standard Whirlpool Operating and Maintenance Manual Comprehensive guide for operating and maintaining American Standard System I and System II Whirlpool baths, including Chromatherapy features and optional heaters. Covers safety, cleaning, and warranty information.
	Gwida għall-Installazzjoni tal-American Standard Mainstream 60" x 32" 8 Jet Integral Apron Whirlpool Speċifikazzjonijiet dettaljati u informazzjoni dwar l-installazzjoni għall-American Standard Mainstream 60" x 32" 8 Jet Integral Apron Whirlpool, inklużi d-dimensjonijiet, il-karatteristiċi, u ċ-ċertifikazzjonijiet ta' konformità.
	Gwida għall-Installazzjoni tal-Banju Whirlpool tas-Serje 2460/2461 tal-American Standard Cambridge Gwida dettaljata għall-installazzjoni għall-pixxini tal-idromassaġġ u tal-għawm tas-serje American Standard Cambridge 2460 u 2461. Tkopri l-ispeċifikazzjonijiet tal-prodott, l-installazzjoni tal-qafas u l-inċiżjonijiet, ir-rekwiżiti tal-wajers elettriċi, il-konnessjoni tad-drenaġġ, l-ittestjar tas-sistema, u t-tindif wara l-installazzjoni. Tinkludi twissijiet ta' sigurtà u informazzjoni ta' kuntatt.
	American Standard Residential Gas Water Heater: Operating, Installation, and Service Manual Comprehensive guide for American Standard residential power vent gas water heaters with VAPORSHIELD Technology. Covers operation, installation, safety, troubleshooting, and maintenance. Features a toll-free support number for assistance.
	Gwida għall-Utent tal-Kontroll tal-Kumdità tat-Touchscreen Nexia tal-American Standard ACONT624AS42DA Gwida għall-utent għall-American Standard ACONT624AS42DA Nexia Touchscreen Comfort Control, li tiddeskrivi l-karatteristiċi, it-tħaddim, is-settings tal-utent, l-iskedar, l-integrazzjoni tan-netwerk Z-Wave, l-aġġornamenti tal-firmware, il-garanzija, u l-konformità mal-FCC/IC.

Standard Amerikan 9075120