RECOIL SS65

RECOIL SS65 Ultra-Thin 6.5" Active Under Seat Car Subwoofer Instruction Manual

Introduzzjoni

Welcome to the RECOIL SS65 Ultra-Thin 6.5" Active Under Seat Car Subwoofer manual. This document provides essential information for the safe and effective use of your new car audio component. Please read this manual thoroughly before installation and operation.

The RECOIL SS65 is engineered to deliver powerful bass in a compact form factor, fitting conveniently under most vehicle seats. It features a 6.5-inch low-impedance woofer, a built-in Class D amplifier, and VB BASS Virtual Bass Enhancement technology, ensuring a rich audio experience without sacrificing cabin space.

Prekawzjonijiet tas-Sigurtà

To prevent injury or damage to the unit, please observe the following safety guidelines:

  • Installazzjoni Professjonali Rakkomandata: If you are unsure about installation procedures, consult a qualified car audio technician.
  • Skonnettja l-batterija: Always disconnect the vehicle's negative battery terminal before beginning any electrical work to prevent short circuits.
  • Evita l-umdità: Tesponix is-subwoofer għall-ilma jew umdità eċċessiva.
  • Ventilazzjoni xierqa: Ensure the subwoofer is installed in a location with adequate airflow to prevent overheating.
  • Wiring korrett: Use appropriate gauge wiring and ensure all connections are secure and properly insulated. Incorrect wiring can cause damage to the unit or vehicle.
  • Immuntar Sikur: Immonta s-subwoofer sew biex tevita li jsir projettili f'każ ta' waqfien f'daqqa jew aċċident.

Kontenut tal-Pakkett

Ivverifika li l-oġġetti kollha huma preżenti fil-pakkett tiegħek:

  • RECOIL SS65 6.5" Active Under-Seat Car Subwoofer
  • Adapter RCA
  • Wired remote knob
  • Parentesi tal-immuntar
  • Pads kontra l-vibrazzjoni
  • Manwal għall-Utent (dan id-dokument)
RECOIL SS65 Accessory Pack showing subwoofer, user manual, RCA adapter, remote knob, mounting brackets, and anti-vibration pads.

Image: Contents of the RECOIL SS65 package, including the subwoofer, user manual, RCA adapter, remote knob, mounting brackets, and anti-vibration pads.

Prodott Overview

Low-Impedance Design

The SS65 features an exclusive 0.4 Ohm low-impedance woofer paired with a high-current Class D amplifier. This design maximizes power transfer and efficiency, resulting in deeper bass and cleaner sound with reduced distortion.

RECOIL SS65 subwoofer highlighting its 6.5 inch size, 250 Watts RMS, 0.4 Ohm impedance, and 3 inch height.

Image: The RECOIL SS65 subwoofer with callouts for its 6.5-inch size, 250 Watts RMS power, 0.4 Ohm impedance, and 3-inch height, illustrating its compact and powerful design.

VB BASS Virtual Bass Enhancement

Integrated DSP technology enhances low-frequency perception, making the bass sound larger and more impactful, especially beneficial for factory audio systems.

Kontrolli u Konnessjonijiet

The SS65 offers comprehensive tuning controls for optimal sound customization. Familiarize yourself with the input and output panel:

RECOIL SS65 input and output panel with labels for Bass Boost, X-Over, Phase, VB Bass, Gain, Remote, RCA Level Input, and Power Connector.

Immaġni: Dettaljata view of the RECOIL SS65's input and output panel, showing labeled controls for Bass Boost, Low-Pass Crossover (X-Over), Phase Shift, VB Bass, Input Gain, Remote Bass Level, RCA Level Input, and the Power Connector.

  • LED tal-Istat tal-Enerġija: Indicates the operational status of the subwoofer.
  • Spinta baxxa: Adjusts the level of bass enhancement.
  • X-Over (Low-Pass Crossover): Sets the upper frequency limit for the subwoofer.
  • Phase Shift (0°/180°): Adjusts the phase of the subwoofer output.
  • VB Bass (ON/OFF): Activates or deactivates the Virtual Bass Enhancement.
  • Gwadan Kontroll: Jaġġusta s-sensittività tal-input.
  • Remote Bass Level Input: Connection for the wired remote control.
  • RCA Level Input: Għall-konnessjoni ma' unitajiet ewlenin b'RCA pre-outs.
  • Konnettur tal-Qawwa: Terminals for +12V, Remote (REM), and Ground (GND) connections.

Dimensjonijiet u Pjazzament

The ultra-thin design of the SS65 allows for flexible placement options, most commonly under a vehicle seat.

RECOIL SS65 subwoofer installed under a car seat, demonstrating its space-saving design.

Image: The RECOIL SS65 subwoofer discreetly placed under a car seat, illustrating its compact form factor and minimal intrusion into cabin space.

RECOIL SS65 subwoofer showing its dimensions: 8.62 inches (219mm) length, 7.64 inches (194mm) width, and 3.00 inches (77mm) height.

Immaġni: Fuq u ġenb views of the RECOIL SS65 subwoofer with precise measurements, indicating its length of 8.62 inches (219mm), width of 7.64 inches (194mm), and height of 3.00 inches (77mm).

Setup u Installazzjoni

Qabel Tibda

  • Skonnettja t-terminal negattiv tal-batterija tal-vettura.
  • Plan your wiring path to avoid interference and ensure proper length.
  • Choose a mounting location that provides adequate ventilation and is secure.

Immuntar tas-Subwoofer

Secure the subwoofer using the provided mounting brackets and anti-vibration pads. Ensure the unit is firmly attached to a solid surface to prevent movement. Allow sufficient space around the unit for heat dissipation.

Konnessjonijiet tal-Wiring

Follow these steps for proper wiring. Refer to the 'Controls and Connections' image for visual guidance.

  1. Konnessjoni tal-Enerġija (+12V): Connect the +12V terminal on the subwoofer to the vehicle's positive battery terminal. An in-line fuse (not included, but highly recommended) should be installed as close to the battery as possible.
  2. Konnessjoni mal-art (GND): Connect the GND terminal to a clean, unpainted metal surface on the vehicle chassis. Ensure a solid, low-resistance connection.
  3. Tixgħel mill-Bogħod (REM): Connect the REM terminal to the remote turn-on output of your head unit. This wire signals the subwoofer to turn on and off with your car's audio system. If your head unit lacks a dedicated remote output, you may use an ignition-switched 12V source, or utilize the high-level input's auto-sense feature if available.
  4. Input Awdjo:
    • Input RCA: If your head unit has RCA pre-outs, connect RCA cables from the head unit to the subwoofer's RCA inputs.
    • Input ta' Livell Għoli: If your head unit does not have RCA outputs, use the provided high-level input adapter to connect directly to your vehicle's speaker wires.

Tħaddim tas-Subwoofer

Initial Setup and Gain Adjustment

  1. Wara li jsiru l-konnessjonijiet kollha, erġa' qabbad it-terminal negattiv tal-batterija tal-vettura.
  2. Turn on your car audio system.
  3. Set the subwoofer's GAIN control to its minimum position.
  4. Play music with strong bass content at a moderate volume level from your head unit.
  5. Slowly increase the GAIN control on the subwoofer until the desired bass level is achieved without any audible distortion. If distortion occurs, reduce the gain slightly.

Kontrolli tal-irfinar

  • Kontroll GAIN: Adjusts the input sensitivity to match the output voltage of your head unit. Proper gain setting is crucial for optimal performance and to prevent distortion.
  • LOW-PASS CROSSOVER (X-OVER): This control sets the upper frequency limit for the subwoofer, typically adjustable from 50Hz to 150Hz. Frequencies above this setting will be filtered out, ensuring the subwoofer only reproduces low-frequency sounds. Adjust this to blend smoothly with your main speakers.
  • Swiċċ tal-FAŻI (0°/180°): This switch adjusts the phase of the subwoofer's output relative to your main speakers. Experiment with both 0° and 180° settings to find the one that provides the most impactful and cohesive bass response in your vehicle.
  • Boost Bass: Provides an adjustable bass enhancement (+0-12dB) at a specific low frequency. Use this control sparingly to add extra punch to your bass. Excessive use can lead to distortion.
  • VB BASS: Toggles the Virtual Bass Enhancement DSP on or off. Activate it for an enhanced low-frequency perception, making the bass sound fuller.

Kontroll mill-bogħod bil-fili

The included wired remote allows for convenient, on-the-fly adjustment of the bass level from the driver's seat. Connect the remote to the "REMOTE" port on the subwoofer. This control only adjusts the bass level and does not affect other tuning settings.

Manutenzjoni

The RECOIL SS65 is designed for durability and requires minimal maintenance. Follow these guidelines to ensure its longevity:

  • Tindif: Żomm is-subwoofer nadif u ħieles mit-trab u l-fdalijiet. Uża drapp artab u niexef għat-tindif. Evita li tuża kimiċi ħarxa jew prodotti tat-tindif li joborxu.
  • Ventilazzjoni: Ensure that the area around the subwoofer remains clear to allow for proper airflow and prevent overheating.
  • Kundizzjonijiet Ambjentali: Evita li tesponi l-unità għal temperaturi estremi, dawl tax-xemx dirett għal perjodi twal, jew umdità eċċessiva.

Gwida dwar is-sejbien ta 'problemi

If you encounter issues with your RECOIL SS65 subwoofer, consult the table below for common problems and solutions:

ProblemaKawża PossibbliSoluzzjoni
Ebda Qawwa / LED tal-Qawwa Mitfi
  • Fjus minfuħ
  • Konnessjoni maħlula tal-enerġija jew tal-art
  • L-ebda sinjal ta' mixgħul mill-bogħod
  • Check and replace the in-line fuse (if applicable) and the subwoofer's internal fuse.
  • Verify all power (+12V), ground (GND), and remote (REM) connections are secure.
  • Ensure the head unit's remote output is active or use an ignition-switched 12V source.
Ebda Output tal-Ħoss
  • Konnessjoni mhux korretta tad-dħul tal-awdjo
  • Il-kontroll tal-qligħ huwa ssettjat baxx wisq
  • Il-volum tal-unità prinċipali huwa baxx wisq jew immut
  • Crossover frequency set too high or low
  • Iċċekkja l-konnessjonijiet tal-input RCA jew ta' livell għoli.
  • Żid il-kontroll tal-GAIN gradwalment.
  • Ensure the head unit is on and volume is up.
  • Adjust the LOW-PASS CROSSOVER to an appropriate range (e.g., 80-120Hz).
Ħoss Mgħawġ
  • Gain control set too high
  • Il-Bass Boost huwa ssettjat għoli wisq
  • Incorrect crossover or phase setting
  • Sors awdjo ta 'kwalità fqira
  • Naqqas il-kontroll tal-GAIN.
  • Lower the BASS BOOST level.
  • Adjust the LOW-PASS CROSSOVER and PHASE switch for optimal sound.
  • Ipprova sors awdjo differenti biex teskludi problemi bis-sors.
Weak or Lackluster Bass
  • Gain control too low
  • Phase switch incorrect
  • Crossover frequency too low
  • VB Bass off
  • Increase the GAIN control.
  • Toggle the PHASE switch (0°/180°) to find the best setting.
  • Adjust the LOW-PASS CROSSOVER to a slightly higher frequency.
  • Ensure VB Bass is turned ON.

Speċifikazzjonijiet Tekniċi

KaratteristikaSpeċifikazzjoni
BrandREKOLL
Isem / Numru tal-MudellSS65
Tip ta' KelliemSubwoofer
Qawwa tal-Ħruġ Massimu tal-Ispeaker250 Watts
Teknoloġija tal-KonnettivitàRCA
Tip ta 'ImmuntarKarozza Mount
Dimensjonijiet tal-Prodott (P x W x H)7.62 x 19.41 x 21.89 ċm (3.00 x 7.64 x 8.62 pulzieri)
Piż tal-oġġett4.4 kg
Għadd ta' Unitajiet1.0 Għadd
Midja Inkorporata6.5" Under-Seat Car Subwoofer, RCA adapter, remote knob, mounting brackets, and anti-vibration pads.
ManifatturREKOLL
Post tan-Negozju3757 E Broadway Rd Suite 3 Arizona Phoenix 85040

Garanzija u Appoġġ għall-Klijent

Informazzjoni dwar Garanzija

For detailed warranty information regarding your RECOIL SS65 subwoofer, please refer to the warranty card or documentation included with your original purchase. Keep your proof of purchase for any warranty claims.

Appoġġ għall-Klijent

Should you require technical assistance, have questions about installation, or need to report an issue, please contact RECOIL customer service directly. You can typically find contact information on the manufacturer's websit jew permezz tal-bejjiegħ bl-imnut tiegħek.

Informazzjoni ta' Kuntatt tal-Manifattur:
REKOLL
3757 E Broadway Rd Suite 3
Phoenix, Arizona 85040

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.