Radiomaster Pocket Hall Gimbal Transmitter Remote Control Manual

Introduzzjoni

The Radiomaster Pocket is a compact and lightweight remote control transmitter designed for various RC applications. It features Hall gimbals, a foldable antenna, and is available in different versions, including CC2500 and ExpressLRS. This manual provides essential information for setting up, operating, and maintaining your Radiomaster Pocket.

X'hemm fil-Kaxxa

Iċċekkja li l-oġġetti kollha elenkati hawn taħt huma inklużi fil-pakkett tiegħek:

• 1 x Pocket Radio
• 1 x Borża tal-Ġarr Personalizzata
• 1 x Cable USB-C
• 1 x Screen Protector
• 1 x Stiker
• 1 x Manwal (dan id-dokument)
• 4 x Low Tension Springs (for gimbals)

Prodott Overview

The Radiomaster Pocket is designed for portability and performance. Key features include:

• Hall Effect Gimbals: For smooth centering and precise response.
• Dwal LED inkorporati: To visualize your inputs.
• Disinn li jinġarr u ħafif: Faċli biex tittrasporta u taħżen.
• Foldable Antenna: Ittejjeb il-portabbiltà.
• Removable Stick Ends: For customization and compact storage.
• Skrin LCD backlit: Offers a clear balance of size and functionality.
• External Module Bay: Compatible with RadioMaster Nano-size modules and TBS Nano Crossfire/Nano Tracer.
• 18650 Kompatibilità tal-Batterija: Provides extended battery life (batteries not included).
• Pre-installed EdgeTX Firmware: Ready for advanced customization and control.

Setup

1. Installazzjoni tal-batterija

The Radiomaster Pocket requires two 18650 batteries (not included). To install:

1. Sib il-kompartiment tal-batterija fuq wara tat-trasmettitur.
2. Iftaħ l-għatu tal-kompartiment.
3. Insert two 18650 batteries, ensuring correct polarity.
4. Agħlaq l-għatu tal-kompartiment tal-batterija sew.

2. L-Ewwel Tixgħil

Press and hold the power button located on the front of the transmitter until the screen illuminates and the EdgeTX firmware loads. The transmitter will perform a self-check upon startup.

3. Tmiem l-Antenna u l-Istikek

• Antenna: Unfold the antenna to its upright position for optimal signal transmission. Fold it down for storage.
• Stick Ends: The transmitter comes with removable stick ends. You can customize them or remove them for more compact storage.

Istruzzjonijiet Operattivi

1. Kontrolli Bażiċi

Iffamiljarizza ruħek mal-kontrolli ewlenin:

• Gimbals: Control primary flight surfaces (throttle, rudder, aileron, elevator).
• Buttuni tat-Trim: Used for fine-tuning channel outputs.
• Buttuni tan-Navigazzjoni: For menu navigation on the LCD screen.
• Buttuna tal-Qawwa: Turns the unit on/off and can be used for menu selection.

2. Aġġustament tal-Gimbal

The gimbals can be adjusted for tension and self-centering. Refer to Figure 7 for adjustment points:

• A (I-R): Turn clockwise to disable self-centering (throttle). Turn counter-clockwise to enable self-centering (throttle).
• B (T): To adjust the throttle stick tension. Turn clockwise to increase stick tension. Turn counter-clockwise to decrease stick tension.
• C (UP-DOWN): Turn clockwise to increase vertical stick tension. Turn counter-clockwise to decrease stick tension.
• D (LEFT-RIGHT): Turn clockwise to increase horizontal stick tension. Turn counter-clockwise to decrease stick tension.

Speċifikazzjonijiet

Manutenzjoni

• Tindif: Use a soft, dry cloth to clean the exterior of the transmitter. Avoid using harsh chemicals or solvents.
• Ħażna: Aħżen it-trasmettitur f'post frisk u niexef 'il bogħod mix-xemx diretta u minn temperaturi estremi. Neħħi l-batteriji jekk se taħżnu għal perjodi twal.
• Aġġornamenti tal-Firmware: Periodically check the official Radiomaster websit għal aġġornamenti tal-firmware biex tiġi żgurata prestazzjoni ottimali u aċċess għal karatteristiċi ġodda.

Issolvi l-problemi

Kwistjonijiet Komuni u Soluzzjonijiet:

• It-trasmettitur mhux qed jixgħel:
  • Kun żgur li l-batteriji huma installati b'mod korrett u kompletament iċċarġjati.
  • Iċċekkja l-polarità tal-batterija.
• No signal to receiver:
  • Verify the antenna is unfolded and in an upright position.
  • Ensure the transmitter and receiver are properly bound. Refer to your receiver's manual for binding instructions.
  • Iċċekkja għal interferenza minn apparati oħra ta' 2.4GHz.
• Gimbal response issues:
  • Check gimbal tension settings as described in the "Gimbal Adjustment" section.
  • Calibrate gimbals through the EdgeTX firmware settings if necessary.

For further assistance, please refer to the official Radiomaster support resources or community forums.

Informazzjoni Importanti dwar is-Sigurtà

• Always operate your RC equipment responsibly and in accordance with local laws and regulations.
• Ensure your batteries are in good condition and charged properly.
• Qatt m'għandek tħaddem il-mudell RC tiegħek ħdejn nies, annimali, jew proprjetà li tista' ssirilha l-ħsara.
• Perform pre-flight checks before each use to ensure all controls are functioning correctly.
• Keep the transmitter away from water and moisture, as it is not water resistant.

Garanzija u Appoġġ

For information regarding warranty coverage, technical support, or service, please visit the official Radiomaster webis-sit jew ikkuntattja lin-negozjant awtorizzat tiegħek. Żomm il-prova tax-xiri tiegħek għal talbiet ta' garanzija.