Introduzzjoni
Thank you for choosing the KOKIDO XTROJET 420 Cordless Robotic Pool Cleaner. This manual provides essential information for the safe and efficient operation, maintenance, and troubleshooting of your new pool cleaner. Please read it thoroughly before first use and retain it for future reference.
Informazzjoni Importanti dwar is-Sigurtà
- Always ensure the pool cleaner is switched off and disconnected from the charger before handling or maintenance.
- Do not operate the cleaner if the battery or charger is damaged.
- Żomm it-tfal u l-annimali domestiċi 'l bogħod miż-żona tal-pixxina meta l-apparat tat-tindif ikun qed jaħdem.
- Uża biss il-ċarġer u l-batterija pprovduti.
- The cleaner is designed for flat-bottom pools up to 850 sq ft (30 feet in length).
- This device is not intended for cleaning algae or very fine silt particles.
Kontenut tal-Pakkett
Ivverifika li l-komponenti kollha huma preżenti:
- Main Unit (KOKIDO XTROJET 420 Robotic Pool Cleaner)
- Ċarġer tal
- Ganċ għall-Irkupru
- Nozzle Cleaning Brush
- Manwal għall-Utent (dan id-dokument)
Setup
1. Iċċarġjar tal-Unità
Before first use, fully charge the robotic pool cleaner. The charging time is approximately 5-6 hours for a full charge, providing up to 75 minutes of cleaning time.
- Kun żgur li l-apparat tat-tindif ikun niexef qabel ma tqabbad il-ċarġer.
- Sib il-port tal-iċċarġjar fuq l-apparat tat-tindif.
- Connect the charger to the unit and then plug it into a power outlet.
- The power indicator lights will show red during charging and turn green when fully charged.
2. Adjusting Cleaning Paths
The XTROJET 420 features an adjustable 3-way path selection switch to optimize cleaning for various pool sizes and shapes. Adjust the pin placement on the front swivel wheel according to your pool dimensions.
Istruzzjonijiet Operattivi
1. It-tqegħid tal-Cleaner fil-Pixxina
- Kun żgur li l-apparat tat-tindif ikun iċċarġjat kompletament.
- Turn on the cleaner by flipping the switch on the top. The indicator light will turn blue.
- Gently lower the cleaner into the pool. It will slowly fill with water and sink to the bottom.
- The motor will automatically activate once the unit is fully submerged and detects water.
2. Ċiklu tat-Tindif
The XTROJET 420 will navigate across the pool bottom, collecting debris. It operates for approximately 75 minutes per charge.
- The cleaner is equipped with a 15.9 GPM suction system and three rollers to enhance cleaning efficiency.
- It effectively captures soft leaves (up to 6 inches), small twigs, dead bugs, sand, and coarse gravel.
- Nota: This cleaner is not designed for algae or very fine silt. For these types of debris, additional pool maintenance methods may be required.
3. Auto-Parking and Retrieval
When the battery is low or the cleaning cycle is complete, the cleaner will automatically park itself near the pool side for easy retrieval.
- Use the included retrieval hook to gently lift the cleaner from the pool.
- Allow excess water to drain from the unit before removing it completely from the pool.
- Turn off the cleaner using the switch on top.
Manutenzjoni
1. Cleaning the Debris Compartment and Filter
Regular cleaning of the debris compartment and filter is crucial for optimal performance.
- After each use, unlatch the four clips on the cleaner to open the top cover.
- Neħħi l-qoffa tal-filtru.
- Empty collected debris from the compartment and rinse both the compartment and the stainless steel filter thoroughly with a garden hose.
- Ensure all debris is removed from the 250µ stainless steel filter.
- Reassemble the filter and close the top cover, ensuring all clips are securely latched.
2. General Pool Maintenance
For a healthy and clean pool, consider these additional steps:
- Skim off leaves and debris from the surface.
- Brush sediment from pool walls to prevent algae.
- Keep your filtration pump running effectively.
- Check and backwash your filter regularly.
- Add chemicals and test your pH value to maintain water balance.
Issolvi l-problemi
| Problema | Kawża Possibbli | Soluzzjoni |
|---|---|---|
| Cleaner does not move or gets stuck in one spot. | Incorrect path setting for pool size/shape; Obstruction; Low battery. | Adjust the 3-way path selection switch. Check for and remove any large obstructions. Ensure the unit is fully charged. |
| It-tindif mhux qed jiġbor il-fdalijiet b'mod effettiv. | Filter basket is full or clogged; Debris is too fine (silt/algae). | Clean the debris compartment and filter thoroughly. Note that the cleaner is not designed for very fine silt or algae. |
| Small pin for wheel adjustment is lost. | Detached during cleaning or maintenance. | Ensure the pin is securely in place before operation. Contact customer service for replacement if lost. |
| Cleaner does not turn on when placed in water. | Not fully submerged; Battery not charged; Power switch off. | Ensure the cleaner is fully submerged. Verify battery is charged. Check that the power switch is in the 'ON' position. |
Speċifikazzjonijiet
| Karatteristika | Dettall |
|---|---|
| Isem tal-Mudell | XTROJET 420 (RC48) |
| Sors tal-Enerġija | Li jaħdem bil-batterija (batterija tal-jone tal-litju inkluża) |
| Tip ta 'batterija | Lithium-Ion, 11.1 Volts, 4000 mAh |
| Ħin tax-Xogħol | minuti 75 |
| Ħin tal-Iċċarġjar | 5-6 sigħat |
| Qawwa tal-ġbid | 15.9 Galluni Kull Minuta (GPM) |
| Debris Capacity | 1.2 Galun |
| Filtrazzjoni | 250µ Stainless Steel Filter, 154 sq inches Effective Filtration Area (EFA) |
| Tip ta' Pool | Above-Ground and Flat Pools (up to 30 feet / 850 sq ft) |
| Dimensjonijiet tal-Prodott | 14.5"T x 15"W x 9"Għ |
| Piż tal-oġġett | 14.35 liri (6.52 kg) |
| Materjal | Stainless Steel |
Garanzija u Appoġġ
The KOKIDO XTROJET 420 comes with a 1-year warranty.
For customer service and support, please refer to the contact information provided with your product or visit the official Kokido website. You can also scan the QR code on the product for user manual and videos: https://qrs.ly/npgbdc4
